Microbit RRC-1258 MkII(s) Manual de usuario descargar pdf (Pagina 32)

USER MANUAL

m crob t

RRC-1258 MKII

Ba1258B_RemoteRig_MkIIs-A33.docx

User manual

Rev. A33 – 2015 Jan 28

32 of 236

The Internal webserver in the RRC will produce a web page like the one above.

Note ! If you have changed the IP-address of the Radio-RRC from the default IP address like

in the example above, remember that you need to change the “SIP-contact” IP-address in the

Control-RRC at the Radio-settings page.

You can now start the configuration via the web

Back to Step By Step setup system setup

Initial IP setup via USB

The initial IP-setup can be done from the Microbit Setup Manager via USB also. This is the

way it had to be done in past. This method is a little bit more complicated for beginners but

can be convenient to use sometimes as no networks connection are needed with this method.

If your RRC has an old firmware (before 2.79) you can upgrade the firmware via the USB

interface before you do the setup (see below).

Connect your RRC to 12V and connect the USB-cable between your computer and the USB

jack on the front of the RRC. Windows will automatically install the necessary drivers. When

it's done the text in the bottom field will change from "RRC not connected" to "RRC-

connected" which is an indication that you are in connection with the unit.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 235 236

Sin comentarios

Microbit RRC-1258 MkII(s) Manual de usuario Pagina 32