Microbit RRC-1258 MkII(s) Manual de usuario descargar pdf (Pagina 13)

USER MANUAL

m crob t

RRC-1258 MKII

Ba1258B_RemoteRig_MkIIs-A33.docx

User manual

Rev. A33 – 2015 Jan 28

13 of 236

Hardware

Front

PWR LED

Green light is indicating normal status. When the green LED is flashing slow the unit is trying

to connect to the Ethernet, normally it only takes a few seconds. If the LED do not end

flashing it's probably something wrong with the network connection or network setup. A fast

flashing power LED indicate that the unit is powered from USB (see USB below).

USB

The USB-interface is used to initially set up the IP parameters. It can also be used for

downloading new software (can also be done via the WEB-interface). At the Control-RRC it

can also be used for CAT control, PTT, RTTY or CW control via the RTS and DTR signals in the

virtual COM-port delivered by the RRC USB device. From Version 6 the RRC can be powered

via the USB to make it easier to update the Firmware. Note that the RRC need to be

connected to 12V DC for normal operation. When the unit is powered from the USB the green

power LED will flash fast.

COM1

COM1 can in special cases be used to set parameters and check statuses if USB or WEB

cannot be used. The COM1 port can also be used for ex. rotator control as it can be

configured as transparent serial port between the RRC:s.

RS-232

Pin no

RS-232 Interface (9-pol D-sub female)

TXD (Out)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 235 236

Microbit RRC-1258 MkII(s) Manual de usuario Pagina 13