Microbit RRC-1258 MkII(s) Manual de usuario descargar pdf (Pagina 130)

USER MANUAL

m crob t

RRC-1258 MKII

Ba1258B_RemoteRig_MkIIs-A33.docx

User manual

Rev. A33 – 2015 Jan 28

130 of 236

ICOM ID-E880

General

The Remoterig system also support ICOM:s D-star radio ID-E880. The technical solution is the

same as for IC-706, IC-7100, TS-480 etc. You can remote control the radio over Internet

from the control panel without any PC. We simply replace the cable between the control

panel and the radio with two RRC-1258 units, one at the control panel and one at the radio.

When you push the PWR-ON button an audio and data connection is established between the

units and you control the radio as you do normally with the control panel directly attached to

the radio.

Hardware configuration

If you have a RRC with harware v7 or later the setup is simple, for hardwares before v7 the

prepararions is a little bit more complicated for the IC-E880 as some modifications must be

done at the Remoterig circuit boards, Check Mods on the website under support. In both

cases the HM-133 adapters must be mounted and a wire must be connected, more info below.

Radio settings (example)

Parameter

Control

Radio

Program mode

13 – IC-E880

SIP password

hello

SIP contact

192.168.0.228

Auto connect

Audio quality

2 – Linear 16 bits 8 kHz

Audio dual-rx (*)

Codec out gain

255

Codec inp gain

Codec inp preamp

Yes

Codec inp HPF Hz

163

COM0 baudrate

38400

COM0 data bits

COM0 stop bits

COM0 parity

0 - Off

(*) Available only in RRC-1258MkIIs

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 235 236

Microbit RRC-1258 MkII(s) Manual de usuario Pagina 130

Comentarios a estos manuales

Microbit RRC-1258 MkII(s) Manual de usuario Pagina 130

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Microbit RRC-1258 MkII(s)