Microbit RRC-1258 MkII(s) Manual de usuario descargar pdf (Pagina 184)

USER MANUAL

m crob t

RRC-1258 MKII

Ba1258B_RemoteRig_MkIIs-A33.docx

User manual

Rev. A33 – 2015 Jan 28

184 of 236

5 TDO - serial data 57600 bps from panel to radio

6 AF - audio to speaker.

The short 6 wire cable with RJ11 connectors supplied by Kenwood should be used between

the Radio and the Radio-RRC.

The long 6 wire cable with RJ11 connectors supplied by Kenwood should be used between the

Control-RRC and the control panel.

The short black CAT-6 patch cable attached with the Remoterig can be used as mic connection

between the Radio-RRC and the radio.

If the TS-480 is provided with a microphone with RJ-45 connector you can connect it directly

to the AUX/MIC connector on the Control-RRC. Older TS-480 has a circular 8 pin connector

then you have to use the adapter cable MJ-88 which was then supplied by Kenwood as a

adapter between the Microphone and the AUX/MIC connector.

Connection type 1

Modular 8-pol connector:

3 MIC- mic Signal

4 MICE - mic ground

5 PTT

6 GND PTT

Connection type 2

Modular 8-pol connector:

3 MIC- mic Signal

4 GND PTT

5 PTT

6 MICE - mic ground

If you use the wrong configuration everything will work but the system will be very sensitive

for HF (RFI).

Power supply

Control-RRC:

The Control-RRC is supplied with a common 13,8 V (10-18V) power supply. The display and

speaker amplifier needs a lot of power so you need at least 1A.

Radio-RRC:

The Radio-RRC could be powered with a separate Power supply or the same as the radio. If

you use the Radio PS make sure you have a 1A fuse on the output to the RRC. Do not connect

it direct to a 20-40A PS the cable will melt if something happens.

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 235 236

Microbit RRC-1258 MkII(s) Manual de usuario Pagina 184