Microbit RRC-1258 MkII(s) Manual de usuario descargar pdf (Pagina 116)

USER MANUAL

m crob t

RRC-1258 MKII

Ba1258B_RemoteRig_MkIIs-A33.docx

User manual

Rev. A33 – 2015 Jan 28

116 of 236

- Identify the end with the connector to the

radio, se above.

- Cut the cable apart, don't make it longer

then needed at radio end. The mic signal is

sensitive of HF from antennas etc. as usually.

- Take away about 40 mm of the outer

covering.

- Separate the shields from the inner wire,

the red wire has a copper coloured shield and

the white has a green shield. The shielded

white wire is thinner than the white one

without a shielding. That way you can identify

them from each other. The outer shielding is

not connected to the RRC.

- Cut all wire to about 20 mm. Take way

about 3 mm of the cover from each wire and

tin-plate them. It's not easy but it's possible.

- Also tin-plate the copper and green

shielding.

- Use the supplied CAT-5 cable cut of 10-15 cm from each connector and take away 40 mm

of the outer cover.

- Separate the pairs.

- Take away 3 mm of the cover from each wire and tin-plate them.

- Identify the following colours:

1. Orange/White

2. Orange

3. Green/White

4. Blue 5. Blue/White

6. Green

7. Brown/White

8. Brown

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 235 236

Sin comentarios

Microbit RRC-1258 MkII(s) Manual de usuario Pagina 116